Installation Instructions; Plan Your Project; Window Types; Door Types. Water Resistive Barrier (House Wrap): Windows/Doors must be integrated with a water.
Window Installation Skills Do you have the necessary skills to replace your own windows? The level of skills needed to replace your own windows can vary, depending on the replacement project type. Installing a, for example, is more complex than installing an. An insert replacement window allows you to keep the existing window frame and trim, whereas a full-frame replacement window requires a complete tear-out and replacement of the existing one. A good place to start for determining the magnitude of a replacement project (and if your skills match the project) is to review the product installation instructions or watch our. The Right Tools Do you have the right tools to do the replacement job yourself?
Andersen window installation guides provide product-specific lists of the required tools and materials, but most installation projects require a few standard tools:. Safety glasses.
Caulk gun. Waterproof shims.
![Installing Installing](http://diydiva.net/wp-content/uploads/2010/09/installing1.png)
Tape measure. Level. Hammer. Power drill/driver. Screwdriver.
Putty knife. Utility knife. Small pry bar 3.
A Realistic Schedule Do you have enough time to set aside for your project? A full-frame window replacement requires at least 4 to 6 hours per window on the ground level—and more for windows on upper floors. Insert windows may require less time. It’s always best to set aside additional time for reading through your installation guides thoroughly. Common installation terms are listed below. For additional information Fastening: Windows/Doors must be fastened to a structural member in the rough opening. Fastener type and attachment method are dependent on a number of factors such as window/door type, assemblies, wall type, construction type, structural anchoring material, location, and fastener embedment depth.
Flashing: Windows/Doors must be flashed to integrate the window/door into the drainage plane. Flashing must be applied shingle fashion to direct water to the exterior.
Flashing materials may be straight or formable self-adhered tape or liquid applied. The water management system may be of the drainage or barrier type. Opening Preparation: Openings must be sized to accommodate the window/door and to allow adequate room for squaring, shimming, insulating the window/door or assembly; and any additional allowances that must be made to include flashing material stack-up, and joining materials and fasteners. Sealing: Windows/Doors must be sealed to the drainage plane and rough opening. Backer rod is used to limit the sealant depth between the window frame and the rough opening, cladding, or trim. Sealant is used to prevent water and air infiltration by bridging the gap between the rough opening, window frame, and installation flange. Low expanding foam can also be used to provide an air seal between the window/door frame and the rough opening.
Shimming: Windows/Doors are shimmed to plumb, level, and square the window/door in the rough opening properly and to space the window frame off the rough sill. Water Resistive Barrier (House Wrap): Windows/Doors must be integrated with a water resistive barrier. Water resistive barriers may be applied before or after window/door installation. Water resistive barriers may be of the house wrap type or liquid application.